JLG DVSP Series Operator Manual - Manual (Page 57)

SECTION 5 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3121135 – JLG Lift – 5-3
5.3 OPERATOR MAINTENANCE
Lubrication
Hydraulic Oil (HO)
Hydraulic oils must have anti-wear qualities at least to API Service Classification GL-3, and sufficient chemical stability for
mobile hydraulic system service. JLG Industries, recommends Mobilfluid 424 hydraulic oil, which has an SAE viscosity of
10W-30 and a viscosity index of 152.
For cold weather applications, i.e. when temperatures remain consistently below +20°F (–7°C) JLG recommends using
Mobil DTE 13 hydraulic oil.
Aside from JLG recommendations, it is not advisable to mix oils of different brands or types, as they may not contain the
same required additives or be of comparable viscosities. If use of hydraulic oil other than Mobilfluid 424 is desired, contact
JLG Industries for proper recommendations.
NOTE: Refer to Lubrication Chart, Table 5-2 for specific lubrication locations on machine.
HYDRAULIC SYSTEM OPERATING TEMPERATURE RANGE SAE VISCOSITYGRADE
+0° F to +180° F (-18° C to -83° C) 10W
+0° F to +210° F (-18° C to +99° C) 10W-20, 10W-30
+50° F to +210° F (+10° C to +99° C) 20W-20
Table 5-1. - Lubrication Specifications
KEY SPECIFICATIONS
MPG - Multipurpose Grease having a minimum dripping point of 350° F. Excellent water resistance and adhesive
qualities, and being of extreme pressure type. (Timken OK 40 pounds minimum.)
EPGL - Extreme Pressure Gear Lube (oil) meeting API service classification GL-5 or MIL-Spec MIL-L-2105.
HO - Hydraulic Oil. ISO-Vg grade 32, 46.
CL - Chain Lube. Use a good quality chain lubricant