JLG 740AJ Operator Manual - Manual (Page 29)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3121295 – JLG Lift – 2-9
31. Engine Air Filter - No loose or missing parts; no visi-
ble damage; element clean.
32. Battery - Proper electrolyte levels; cables tight, no vis-
ible damage or corrosion.
33. Engine Oil Supply - Full mark on dipstick; filler cap
secure.
34. Muffler and Exhaust System - See Inspection Note.
35. Hydraulic Pumps - See Inspection Note.
36. Engine Tray Pivot - See Inspection Note.
37. Hydraulic Swivel - See Inspection Note.
38. LP Gas Tank - Brackets, hose and fittings secure; no
visible damage, no missing parts. (If Equipped)
39. Flow Valves - See Inspection Note.
40. Tower Boom - No visible damage; wear pads secure.
All cylinders - rod end shafts and barrel-end shafts
properly secured. If Tower Boom does not rest on stop
with machine in the stowed position, this indicates
upright weldment is out of alignment. If out of align-
ment, do not use machine until the upright weldment
has been synchronized in accordance with Section
4.16.
41. Frame - See Inspection Note. (top and underside).
42. Main Boom Sections - No visible damage; wear pads
secure. All cylinders - rod end shafts and barrel-end
shafts properly secured.
43. Upright - In vertical position, relative to the chassis. If
out of alignment, do not use machine until the upright
has been synchronized in accordance with Section
4.16. Refer to Figure 2-6. and Figure 2-7.
Figure 2-5. Daily Walk-Around Inspection. (Sheet 4 of 4)