JLG 600A_AJ Operator Manual - Manual (Page 36)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-14 – JLG Lift – 3121204
29. Oscillating Axle Cylinder (If Equipped) - See Note.
30. Dual Capacity and Horizontal Cutout Limit Switch - No
damage to the switch, arm free to move, and free from
dirt and grease.
31. Oscillating Axle (If Equipped)- See Note.
32. Engine Air Filter - Element clean.
33. Battery - Proper electrolyte levels; cables tight, no visi-
ble damage or corrosion.
34. Engine Oil Supply - Full mark on dipstick; filler cap
secure.
35. Muffler and Exhaust System - See Note.
36. Hydraulic Pump - See Note.
37. Engine Tray Pivot - See Note.
38. Hydraulic Swivel - See Note.
39. LP Gas Tank (If Equipped) - See Note.
40. Flow Valves - See Note.
41. Tower Boom/Upright - Wear pads secure. All cylinders
- rod end shafts and barrel-end shafts properly
secured. Upright in vertical position. If Tower Boom
does not rest on stop with machine in the stowed
position, this indicates upright is out of plumb.
42. Frame - See Note.
43. Main Boom Sections - Wear pads secure. All cylinders
- rod end shafts and barrel-end shafts properly
secured.
44. Platform Pivot Pin - See Note.
Figure 2-6. Daily Walk-Around Inspection Points - Sheet 3 of 3