JLG 600A_AJ Operator Manual - Manual (Page 8)

TABLE OF CONTENTS
ii – JLG Lift – 3121204
SECTION - PARAGRAPH, SUBJECT PAGE SECTION - PARAGRAPH, SUBJECT PAGE
Platform Rotation . . . . . . . . . . . . . . . . . . . . . . . . 4-6
4.7 BOOM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Swinging the Boom . . . . . . . . . . . . . . . . . . . . . . 4-8
Raising and Lowering the Tower Boom . . . . . . 4-9
Raising and Lowering the Main Boom . . . . . . 4-10
Telescoping the Main Boom . . . . . . . . . . . . . . 4-10
4.8 SHUT DOWN AND PARK . . . . . . . . . . . . . . . . . . . 4-10
4.9 OSCILLATING AXLE LOCKOUT TEST
(IF EQUIPPED) . . . . . . . . . . . . . . . . . . . . . . . . . . 4-13
4.10 STEER/TOW SELECTOR (IF EQUIPPED). . . . . . . 4-13
4.11 TOWING (IF EQUIPPED) . . . . . . . . . . . . . . . . . . . . 4-13
4.12 AUXILIARY POWER - NON ADE EQUIPPED
MACHINES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-17
Activating from the Platform Control Station . . 4-17
Activating from the Ground Control Station . . 4-17
4.13 AUXILIARY POWER - ADE EQUIPPED
MACHINES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-18
Activating from the Platform Control Station . . 4-18
Activating from the Ground Control Station . . 4-18
4.14 DUAL FUEL SYSTEM (GAS ENGINE ONLY) . . . . 4-19
Changing From Gasoline to LP Gas . . . . . . . . 4-19
Changing From LP Gas to Gasoline . . . . . . . . 4-19
4.15 RE-SYNCHRONIZE THE LOWER LIFT CYLINDER4-19
Level Override Valve . . . . . . . . . . . . . . . . . . . . 4-19
4.16 TIE DOWN AND LIFTING . . . . . . . . . . . . . . . . . . . .4-20
SECTION - 5 - EMERGENCY PROCEDURES
5.1 GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-1
5.2 INCIDENT NOTIFICATION . . . . . . . . . . . . . . . . . . . .5-1
5.3 EMERGENCY OPERATION . . . . . . . . . . . . . . . . . . .5-1
Operator Unable to Control Machine . . . . . . . . . 5-1
Platform or Boom Caught Overhead . . . . . . . . . 5-2
5.4 EMERGENCY TOWING PROCEDURES . . . . . . . . .5-2
5.5 MANUAL DESCENT (MACHINES PRIOR TO
S/N 70975) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-2
SECTION - 6 - GENERAL SPECIFICATIONS & OPERATOR
MAINTENANCE
6.1 INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . .6-1
6.2 OPERATING SPECIFICATIONS . . . . . . . . . . . . . . . .6-2
Capacities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-4
Engine Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-4
Tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-8
Dimensional Data . . . . . . . . . . . . . . . . . . . . . . . . 6-8
Torque Requirements . . . . . . . . . . . . . . . . . . . . . 6-9
Hydraulic Oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-9
Critical Stability Weights . . . . . . . . . . . . . . . . . . 6-12
Serial Number Locations . . . . . . . . . . . . . . . . . 6-12