JLG G12-55A Service Manual - Manual (Page 171)

9-29 G10-55A, G12-55A
Electrical System
9.8.1 Windshield/Rear Window Washer
Reservoir
The windshield washer motor and reservoir (4) is located
in the cab behind the seat. It is labeled as a unit and
cannot be serviced separately.
a. Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the transmission control lever in
(N) NEUTRAL, engage the park brake and shut the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and the steering wheel, stating that the
machine should not be operated.
3. Open the engine cover. Allow the system fluids to
cool.
4. Properly disconnect the battery.
5. Remove the nuts and the lock washers from the
washer mounting bolts.
6. Pull the washer reservoir out and away from the
mounting bracket.
7. Rotate the washer reservoir, label and remove the
cab harness connectors from the washer reservoir
connectors.
8. Remove the windshield washer hoses from the
reservoir.
b. Disassembly
DO NOT disassemble the pump. The pump is not
serviceable. Replace pump if found to be defective.
c. Installation and Testing
1. Connect the windshield washer hoses to the
reservoir.
2. Connect the cab wiring harness connectors to the
reservoir connectors.
3. Install the reservoir tank onto the mounting bracket.
4. Install the lock washers and nuts and secure.
5. Fill the washer fluid reservoir with washer fluid.
6. Properly connect the battery.
7. Turn the ignition key switch to the RUN position and
press the washer switch. Verify that fluid is sprayed
on both the windshield and rear glass.
8. Close and secure the engine cover.
9. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
MY1220
4