JLG G10-43A (0160005444 & After) Operator Manual - Manual (Page 51)

Section 3 - Controls and Indicators
3-9 31200150
Park Brake
Park brake switch controls the application and release of the park brake. Indicator
light on switch illuminates to indicate brake is applied.
• With the engine running and the park brake switch in "OFF" position (1), park
brakes are disengaged.
• With switch in "ON" position (2), park brake is engaged and transmission will not
engage forward or reverse.
Parking Procedure
1. Using service brake, stop telehandler in an appropriate parking area.
2. Follow “Shut-Down Procedure” on page 4-5.
WARNING
MACHINE ROLL-AWAY HAZARD. Always move park brake switch to "ON"
position, lower boom to ground and stop engine before leaving cab.
WARNING
CRUSH HAZARD. Turning engine off applies the park brake. Applying park brake
or turning engine off while traveling will cause unit to stop abruptly and could
cause load loss. Either may be used in an emergency situation.
OY0123
R
N
F
1
2
BEFORE S/N 0160040675 EXCLUDING
0160040468 & 0160040672
S/N 0160040675 & AFTER INCLUDING
0160040468 & 0160040672