JLG G10-43A (0160005444 & After) Operator Manual - Manual (Page 142)

Section 7 - Lubrication and Maintenance
7-14 31200150
Engine Oil
A. Engine Oil Level Check
1. Perform “Shut-Down Procedure” on page 4-5.
2. Open the engine cover.
3. Remove dipstick (1) and check oil mark. The oil should be between the full (2)
and add (3) marks within the crosshatched area of the dipstick.
4. If oil is low, remove oil fill cap (4) and add motor oil to bring oil up to the full mark
in the crosshatch area.
5. Replace oil fill cap and dipstick.
6. Close and secure the engine cover.
Note: The standard service interval for engine oil and filter is 250 hours maximum.
If an extended service interval is desired, see your engine manual for specific
guidelines for optimizing oil change intervals.
10
OW0970
OW1020
4
1
1
4
3
2
ADD
OY1240
OY2320
4
1
3
2
ADD
JOHN DEERE PERKINS
BEFORE S/N 0160040675 EXCLUDING 0160040468 & 0160040672
S/N 0160040675 & AFTER INCLUDING 0160040468 & 0160040672