JLG G10-43A (0160005444 & After) Operator Manual - Manual (Page 143)

Section 7 - Lubrication and Maintenance
7-15 31200150
Hydraulic Oil
A. Hydraulic Oil Level Check
1. Be sure all cylinders are fully retracted and machine is level.
2. Perform “Shut-Down Procedure” on page 4-5.
3. Open the engine cover.
4. Check level of hydraulic oil at the sight gauge (6) on the hydraulic tank (5). The
oil level should be visible in the gauge window.
5. If hydraulic oil is low, remove oil fill cap (7) from filler neck. Add fluid to bring oil
up to the upper mark on the sight gauge.
6. Replace hydraulic oil fill cap.
7. Close and secure the engine cover.
10
OW0970
OW1030
OY0730
5
6
7
5
6
7
OAL2760
BEFORE S/N 0160040675 EXCLUDING 0160040468 & 0160040672
S/N 0160040675 & AFTER INCLUDING 0160040468 & 0160040672