JLG 24RS Operator Manual - Manual (Page 32)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-2 – JLG Lift – 3121286
Ground Control Station
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CON-
TROL LEVERS OR TOGGLE SWITCHES CONTROLLING PLATFORM
MOVEMENT DO NOT RETURN TO THE OFF POSITION WHEN RELEASED.
(See Figure 3-1., Ground Control Station)
NOTE: The Function Enable switch must be held
down in order to operate Main Boom Tele-
scope, Swing, Main Lift, Platform Level Over-
ride, and Platform Rotate functions.
1. Indicator Panel
The Indicator Panel contains indicator lights that signal
problem conditions or functions operating during
machine operation.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR
SLIGHT LEVELING OF THE PLATFORM. INCORRECT USE COULD CAUSE
THE LOAD/OCCUPANTS TO SHIFT OR FALL. FAILURE TO DO SO COULD
RESULT IN DEATH OR SERIOUS INJURY.
2. Platform Leveling Override
A three position switch allows the
operator to adjust the automatic
self leveling system. This switch is
used to adjust platform level in situ-
ations such as ascending/
descending a grade.
3. Platform Rotate
Provides rotation of the platform.