JLG 24RS Operator Manual - Manual (Page 89)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121286 – JLG Lift – 6-17
mounting stud holes in the wheels. The proper procedure for
attaching wheels is as follows:
1. Start all nuts by hand to prevent cross threading. DO
NOT use a lubricant on threads or nuts.
2. Tighten nuts in the following sequence.
3. The tightening of the nuts should be done in stages. Fol-
lowing the recommended sequence, tighten nuts per
wheel torque.
4. Wheel nuts should be torqued before first road use and
after each wheel removal. Check and torque every 3
months or 150 hours of operation.
1
2
3
4
5
6
7
8
9
Table 6-9. Wheel Torque Chart
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
40 ft lbs (55 Nm) 95 ft lbs (130 Nm) 170 ft lbs (230 Nm)