JLG 723A Operator Manual - Manual (Page 44)

Section 3 - Controls and Indicators
3-6 31200567
Display Screen
1. Joystick Mode: Displays current joystick mode. Joystick mode can be changed
by the machine owner in Operator Tools Menu (level 2 password required). See
Service Manual for information.
a. Loader Joystick Pattern - Displays loader joystick pattern icon on left when
active. See page 3-20.
b. Lift Joystick Pattern - Displays lift joystick pattern icon on right when active.
See page 3-18.
2. Speed: Telehandler travel speed displayed in kilometers per hour (km/h) or
miles per hour (m/h). Travel speed will flash and buzzer sounds if maximum
travel speed is exceeded.
3. Driving Direction and Gear: Displays current driving condition.
a. Direction - Forward (F), Neutral (N) or Reverse (R).
b. Gear - First (1) or Second (2).
4. Engine Speed: Displays engine speed in revolutions per minute (rpm).
5. Operating Hours: Displays total hours of telehandler operation.
6. Boom Angle: Displays boom angle in degrees. 0 degrees indicates horizontal.
7. Continuous Auxiliary Hydraulics and Steering Mode Change:
a. Continuous Auxiliary Hydraulics - Displays flow value (-100% to +100%)
when continuous auxiliary hydraulics is activated. See Section
5 - Attachments and Hitches for details.
b. Steering Mode Change - Assists with steering mode change. See “Steer
Modes” on page 3-27 for details.
8. Anti Theft Code Entry: If active, the four digit code must be entered after system
start. See “Anti Theft” on page 3-26.
OAH1270
8
2
3
4
5
6
7
00
0000
0000
00 F2
RPM
km/h
100
0
00
0000
0000
RPM
km/h
1
DISPLAY SHOWN WITH CONTINUOUS
AUXILIARY HYDRAULICS ACTIVE
DISPLAY SHOWN WITH ANTI THEFT
ACTIVE AT SYSTEM START