JLG 67SL Operator Manual - Manual (Page 49)

SECTION 4 - MACHINE OPERATION
3121321 – JLG Lift – 4-1
SECTION 4. MACHINE OPERATION
4.1 DESCRIPTION
General Description of the Functions and
Components.
The normal location to operate the machine is on the plat-
form. However, the platform control box can be discon-
nected from the platform location and plugged in (for
emergency use, and loading onto a transport vehicle) at the
distribution terminal inside the valve compartment of the
machine.
4.2 STARTING
Ensure Battery Disconnect Switch is not cutting off the bat-
tery power. On the Ground Control Console, select the oper-
ating position (platform vs. ground).
NOTE: If Glow Plug LED illuminates, wait until the LED goes out
before attempting to start the engine.
ENGINE EXPLOSION HAZARD. MACHINE IS EQUIPPED WITH A COLD
START AID. DO NOT USE ADDITIONAL ETHER. FAILURE TO COMPLY
COULD RESULT IN DEATH OR SERIOUS INJURY.
On the selected Operating Console, press the Engine Start
Switch up and hold to start the engine. Release the switch
once engine starts. On the ground control console, select
Outriggers active or disabled.
The Engine Start Switch can also be used to shut the engine
off when the switch is pressed down.
NOTE: The Start Button on the Engine Control box can also be
used to start the engine (refer to Figure 3-2.).