JLG 80HX_HX+6_HXER ANSI Service Manual User Manual
Page 43
SECTION 3 - CHASSIS & TURNTABLE
3120271
– JLG Lift –
3-5
2.
Place bearing cone (4) into bearing cup (3) in small
end of hub.
3.
Press new seal (2) into hub counterbore with flat
metal side facing in. Use a flat object to ensure that
seal is pressed evenly and is flush with hub face.
4.
Lower hub onto spindle (1) with large open end up.
5.
Place bearing cone (6) over end of spindle and into
bearing cup 5.
6.
Place bearing shim (8) over end of spindle and
against bearing cone.
EYE PROTECTION SHOULD BE WORN DURING RETAINING RING
INSTALLATION.
7.
Install new retaining ring (9) completely into spindle
groove and against bearing shim. Ensure retaining
ring is entirely in groove.
8.
Place internal gear (12) onto end of spindle.
9.
Install thrust washers and thrust bearing (39, 40) on
the portion of the spindle which extends into the
internal gear.