JLG 80HX_HX+6_HXER ANSI Service Manual - Manual (Page 62)

SECTION 3 - CHASSIS & TURNTABLE
3-24 – JLG Lift – 3120271
Mounting-Actuator
The Actuator may be mounted in any attitude - there is no
preferred orientation
With no power applied, the actuator is spring loaded to
the minimum fuel position. The Actuator output shaft
rotates toward the maximum fuel position against this
spring through electrical power from the controller. This
rotation is CW (clockwise) on one side of the Actuator, and
CCW (counterclockwise) on the other. If necessary,
reverse the Actuator on its mounting plate so that the
desired direction of rotation is on the desired side to
match the fuel system direction of travel.
Before selecting the mounting location, consider the link-
age that will be required to connect the Actuator output
arm to the butterfly or fuel valve. Read the following sec-
tion on linkages before deciding on a mounting location.
1. Mount Actuator rigidly to the engine location witch
will permit a short, straight linkage to the carburetor
or fuel valve. Avoid very hot areas.
Linkage
1/4 -28 threaded rod and low friction rod-end bearings are
recommended for linkage materials.
Keep the linkage as short and as straight as possible.
The linkage must not rub against the engine, brackets,
hoses, etc. The linkage must be free of friction and lost
motion or "slop"
The following sketch indicates the proper linkage geome-
try for most installations.
Note that the angle between the carburetor arm and the
rod is 70 degrees with the engine at idle.This is very desir-
able! Note also that the Actuator arm travels equally on
either side of a 90 degree angle with the rod. This angular
arrangement will give the proper mechanical gain for
good stability and performance. It may be necessary to
rotate the carburetor arm relative to the butterfly to
achieve this. This can usually be done, and is usually
worth the effort! Below are some workable installations,
with good linkages. Remember, the Actuator can be
turned 180 degrees on its mounting to "reverse" the
spring-loaded direction. Also the Actuator can be
Mounted in any attitude.
The needed travel of the carburetor determines how far
out the Actuator arm the rod is to be attached. Inmost
cases, The carburetor should be moved from closed to
above 10 degrees from full open as the Actuator is moved
min. to max. THEN ALTER THE LENGTH OF THE ROD
SLIGHTLY (PERHAPS 0.030”), SO THAT THE ACTUATOR
IS JUST OFF ITS INTERNAL STOP, AND IS PULLING THE
BUTTER-FLY AGAINST ITS STOP. This insures that the
carburetor can fully close to idle on load dumps, minimiz-
ing over speeds.