Foot pad set installation, Rack mounting – IOGear GCS1208 User Manual
Page 7
Advertising
Step 1
Remove the screws from the left and right sides of the switch (2 screws total) near the front
of the switch.
8-Port USB DVI KVM Switch
AUTO SCAN
K/M RESET
1
2
3
4
5
6
7
8
7
Foot Pad Set Installation
Flip the KVM switch upside down. Peel the protective films off of the foot pads, then stick the
pads to the four corners, as shown in the diagram below.
Rack Mounting
Advertising
This manual is related to the following products: