2N Omega Lite PBX Assistant - manual v1.2 - Manual (Page 6)

2N
®
PBX Assistant
User Manual
– PBX Assistant
6
www.2n.cz
2. 2N

PBX Assistant Putting in Operation
Before putting the 2N

PBX Assistant in operation, make sure that the 2N

XAPI Server SW, which creates the interface between the 2N

OMEGA Lite PBX
and the 2N

PBX Assistant, has been installed and licensed properly.
2.1. 2N

XAPI Server Installation and Putting in Operation
What you need:

2N

OMEGA Lite PBX, v. 4.05rev14 and later

2N

XAPI Server SW (part of the installation CD), v. 1.17E and later

PC serial port - PBX interconnecting cable (included in PBX delivery)

PC supporting WIN XP, Vista (minimum configuration: Pentium
III./512 MB RAM/800 MHz)
What to do:

Interconnect the PBX (RJ12 socket on the left-hand side of the PBX)
and your PC (serial port with a CANNON 9-pin connector) using the serial
interconnecting cable.

Install the 2N

XAPI Server SW from the CD and launch it.
You are recommended to install the 2N

XAPI Server SW to a dedicated PC.