2N Omega Lite Panel - manual v1.0 - Manual (Page 4)

2N
®
- OMEGA Lite
Panel
User’s manual – Panel
4
www.2n.cz
1. PbX PANEL Operation Start
You can put your PbX PANEL in operation in two ways:
1.1. Single-PC and Single-User Installation
This is what you need: - PbX PANEL software;
- serial port - PBX connecting cable (included in the PbX
delivery);
- PC with WIN 98, XP, 2000,..
•
Install the interconnecting serial cable - insert the RJ12 plug into the socket on
the PbX left side and the 9-pin CANNON male connector to the PC serial port.
•
Install the PbX PANEL software from the installation diskette.
•
Having run PbX PANEL, select the None item in the Communication Channel
Selection menu.
•
Select the proper serial port in the Setting - COM Selection menu.
•
Select the COM item in the Setting - Communication Channel Selection
menu.
Once that you have selected any of the Panel - Monitor menu items, the status will
be displayed on the screen.
1.2. Multi-PC Multi-User Installation
This is what you need: - PbX PANEL software;
- XAPI Server software (included in the PBX delivery);
- serial port - PBX connecting cable (included in the PBX
delivery);
- PC with WIN 98, XP, 2000 with installed TCP/IP
protocol support;
- to know the IP address of the PC where XAPI Server
is installed.