2N Omega Series - VoIP manual v1.2 - Manual (Page 65)

2N
®
- OMEGA Lite
Ethernet module
User Manual – Ethernet Module
65
www.2n.cz
5.3. VoIP Line Setting
Use the External lines/Digital line types/VoIP in the PBX configuration tool for
setting the VoIP line.
Set the following:
•
Name – line name of up to 14 characters.
•
Without authoris. – no authorisation check is performed on this line.
•
Private – the line is connected to a private network where no accounting is
performed.
•
Prefix – prefix of up to four digits, which is automatically called after outgoing
line seizure as the first (DID via the superior exchange). The prefix is not written
into the accounting line.
•
Minimum accounting time - time subtracted from the call time for pseudo-
accounting.
•
Priority – an internal line must be of a higher or equal priority to use an external
line.
•
CLIP – enter how the line should be identified for outgoing calls.
•
Remove – enter the number of digits to be removed from the incoming
identification in the inbound direction in order that the remaining digits are the
DID to the subscriber or the ringing table.
•
Dial to VoIP [s] – maximum delay before the next VoIP line dialling. The
timeout is reset after every digit received from the internal subscriber and the
dialling mode is changed into the calling mode after its expiry. If enabled, the
expiry and thus the dialling end are announced by a short beep. Any later
dialling is considered a service into the call.
5.4. Outgoing Calling