2N StarGate/BlueTower v5.7 - Manual (Page 92)

92
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Fallback port (9): set the fallback port. If the fallback port service is
unavailable, the next LCR table row is applied. Select the appropriate
routing rule to set the fallback port in the Gateway configuration
Port /
. modes
Tariffs – select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the GSM outgoing groups subsection for details.
Ignore tone detection in last group – having detected a user defined tone
(refer to GSM basic settings), the GSM gateway automatically terminates the call
and seeks for another call setup way. If this parameter is activated, the GSM
gateway ignores the tone detection results and sets up a call when this is the
only possible call establishing way.
CLIP Routing Table + CallBack
Use the table to set a fixed CLIP assignment of incoming CLIPs from GSM to the
numbers of extensions to which incoming calls are routed automatically. Also, set the
CLIP list in the GSM network for which CallBack is enabled.
GSM number (CLIP) – user Id in GSM/UMTS.
Used Service
Autodial – enable/disable CLIP routing for the selected CLIP.
Reject call – reject call for the selected CLIP.
Ignore call – ignore call for the selected CLIP
Tone dial-in – incoming GSM calls is accepted + dialtone is activated for
the selected CLIP
Disa message dial-in – incoming GSM calls is accepted + voice
message is activated for the selected CLIP
Dial to VoIP – VoIP destination number for the CLIP routing function.
Auto CallBack – enable/disable CallBack routing for the selected CLIP.
Call duration limit – set the maximum call duration (minutes).
Ethernet Configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in 2N StarGate /
®
. BlueTower
Note
If you use tariff routing, set the tariffs properly in the GSM outgoing
groups subsection
The maximum count of LCR table records is 256.
Tip
CallBack detects the CLIP from right to left. Thus, configure 10 rules for all
the incoming CLIPs to make CallBack work properly. Each of the rules
must contain one of the CLIPs: 0,1,2,3,4,5,6,7,8,9.
Note
Remember to activate the CallBack mode in the GSM incoming groups
for a proper function.
The maximum count of CLIP routing table records is 96.