6 interfaces, 1 interface setup, 2 24 v dc power supply – ADS-TEC OPC7013/7015/7022 User Manual
Page 28: 3 usb connections, Nterfaces
Industrial PCs OPC7013/7015/7022
28
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
6
I
NTERFACES
6.1
I
NTERFACE SETUP
INTERFACE
IRQ
ADDRESS
COM1
4
3F8h-3FF
Pos : 27 /D atent ec hni k/Schnitts tell en/Spannungs versorgung/Spannungs versorg ung f ür OPC 7000-Serie @ 2\ mod_1270724385376_6.doc @ 7572 @
6.2
24
V
DC
POWER SUPPLY
This power supply is provided to the device by using a lead-through terminal with a screw
connection. (The figure shows the socket inside the device)
Technical data of the power adapter
•
Input
voltage:
19…29V
DC
•
Max. switch-on current: 7A
(10ms)
Pos : 28 /D atent ec hni k/Schnitts tell en/USB-Ansc hlus s/U SB-Ansc hl uss f ür OPC / IPC / C PC / PLC / OTC / ITC / VMT / M SD-Serie @ 0\ mod_1158923823971_6.doc @ 547 @
6.3
USB
CONNECTIONS
The USB interfaces are used for connecting peripherals with USB connection. The interface
complies with the USB 2.0 standard.
PIN NUMBER
SIGNAL NAME
1
VDC
2
D -
3
D+
4
GND
Note:
The USB interfaces can be locked by using the "Lock USB" software tool.
USB
CONNECTION IN THE FRONT PANEL
One USB interface can be accessed from the front. The interface is located under a plastic
cover underneath the display. The cover has a tab on the right-hand side, which is used
for opening. The plastic cover of the USB interface must be returned in protective position
after use.
Pos : 29 /D atent ec hni k/Schnitts tell en/Netz werkansc hlus s RJ 45/Netz wer kansc hluss RJ 45 für O PC / IPC / C PC / PLC / OTC / ITC / VMT-Serie/ LSI 5015 SEW @ 0\ mod_1158924094127_6. doc @ 549 @
PIN NUMBER
SIGNAL NAME
1
24 V DC
2
PE
3
0 V DC