ADS-TEC OPC7013/7015/7022 - Manual (Page 32)

Industrial PCs OPC7013/7015/7022
32
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
8 S OFTWARE & DRIVER INSTALLATION
The device will be delivered with a pre-installed Windows / Linux operating system
depending on what the customer wants. The drivers required for this are already installed
and the operating system will be enabled by entering the licence information. Should an
initial installation be required, please proceed according to the following steps. With a
newer operating system like Windows XP, the network card and graphics card will properly
be recognised during the initial installation, so that only the touch screen driver and the
soft keyboard must be installed separately.
Note:
If the hard drive was formatted, the operating system can be reinstalled by using one of
the existing interfaces.
An external keyboard is required for installation.
8.1 I NSTALLING THE OPERATING SYSTEM
The device does not have any integrated CD drive. The installation of the operating system
can therefore only be carried out by using the USB interface.
Procedure for installation:
• The boot drive in the system BIOS must be switched to USB in order to be able to
boot the device from the USB interface.
• Restart the device and insert a Windows CD.
• Install Windows and set up the basic data.
• With devices including a touch screen monitor, the touch screen driver as well as
the soft keyboard should be installed in order to ensure full functionality.
With Windows CE or Windows XP embedded, a complete image can also be installed by
using a USB stick.
Pos : 34 /D atent ec hni k/Sof t war e / Trei ber Install ati on/Touc h Screen/Touc h Screen I nst allation f ür OPC 7000 @ 2\ mod_1271148800775_6. doc @ 7622 @