ADS-TEC IRF2000 User Manual - Manual (Page 18)

IRF2000 series 17
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
5.2 Operational LED status indicators
5.2.1 Behaviour of the status indicators during the boot-up process
The boot-up process starts as soon as the firewall is supplied with a power source. The PWR LED is
used to check whether the firewall is booting. The PWR LED illuminates green and flashes slowly.
5.2.2 Behaviour of the status indicators when resetting to default settings
The Factory Default pushbutton is used to reset the firewall back to the default factory settings at any
time, independent of its configuration.
To reset the firewall to the default settings, the Factory Default pushbutton must be pressed prior to the
boot-up process and held down for approx. 10 seconds during the boot-up process. The PWR LED
flashes rapidly while resetting to factory settings.
As soon as the PWR LED lights up constantly, it is possible to access the web interface.
5.2.3 Behaviour of the status indicators during a firmware update
A firmware update can be performed via the web interface.
The PWR LED flashes rapidly during the firmware update.
The actual update procedure takes a few minutes.
Initialisation begins after the update procedure has been performed successfully.
The PWR LED flashes slowly during this phase.