ADS-TEC IRF2000 User Manual - Manual (Page 8)

IRF2000 series 7
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
2.1 Safety instructions
ATTENTION
To prevent damage to the device, all cable lines
(power supply, interface cables) must be only be
connected while the device is switched off.
ATTENTION
All installation work performed on the device must
be performed only under safe, secure and de-
energised conditions.
CAUTION
Warning - hot surface
Protective gloves must be worn when handling
devices with ambient temperatures of 50 °C and
higher.
Disregarding this warning can result in burn
injuries or damage to property.
Recommendation for use:
Always adhere to the safety measures applicable when handling components at
risk of being damaged by electrostatic discharges.
(DIN EN 61340-5-1 / DIN EN 61340-5-2)
2.2 Operating location
This device is designed for industrial use. Make certain that the specified environmental conditions are
maintained at all times. Use in non-specified environments, i.e., on board ships, in explosive
atmospheres or at extreme elevations, is prohibited.
ATTENTION
Risk of short circuit!
To prevent the formation of water condensate,
the device may be turned on only after it has
reached the specified ambient temperature. This
also applies if the device is exposed to extreme
temperature fluctuations.
To avoid overheating in operation:
The device must not be exposed to direct
radiation by sunlight or any other light or heat
source.
2.3 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.