ADS-TEC IRF2000 User Manual - Manual (Page 6)

IRF2000 series 5
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
1.6 Trademarks
It is noted that any software and/or hardware trademarks and any company brand names as mentioned
in this documentation are all subject to the general trademark, brand name and patent protection rights.
Windows®, Windows® CE are registered trademarks of Microsoft Corp.
Intel®, Atom™, Core™ are registered trademarks of Intel Corp.
IBM® is a registered trademark of IBM Corp.
All other nationally and internationally known trademarks and product names are hereby acknowledged.
In the case of infringement of trademark rights, ads-tec reserves the right to exercise all rights.
1.7 Copyright
This instruction manual including all images contained herein is subject to copyright. Third-party use of
this instruction manual that infringes on the copyright terms is forbidden. Reproduction, translation, or
electronic and photographic archiving or alteration requires the express written consent of ads-tec
GmbH.
Infringements or violations shall result in an obligation to provide compensation for damages.
1.8 Standards
This device is compliant with the provisions and safety objectives of the following EU directives:
Standards

This device is compliant with the CE mark test requirements as defined in the
European test standards EN 55022 and EN 50082-2

This device is compliant with the DIN EN 60950 (VDE0805, IEC950) testing
specifications on “Information technology equipment – Safety"

This device is compliant with the DIN EN 60068-2-6 testing specifications
(sinusoidal vibration)

This unit is compliant to the DIN EN 60068-2-29 (shock and bump) testing
specification
Recommendation for use:
A corresponding declaration of conformity is available for competent authorities at
the manufacturer and can be viewed upon request.
For full compliance with the EMC legislation, all components and cables
used for device connection must also be compliant with these requirements.
It is therefore necessary to employ BUS and LAN cables with shielded
connectors and these must be installed as per the instructions contained in
the instruction manual.