ADS-TEC IRF2000 User Manual - Manual (Page 26)

IRF2000 series 25
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
6.2 Manual configuration of the network adapter
Recommendation for use:
The procedure described in the following was prepared using the Microsoft
Windows operating system as an example. If you are using another
operating system, the paths and properties described here may vary.
Open the properties map for your network adapter. The path is as follows:
Network connections> LAN connection> Properties (right mouse-key).
In the dialogue tab that appears, select option: Internet protocol (TCP/IP) and then click on
Properties.
In the following window, select: Use the following IP address
Access to the device is only enabled if the following parameters are entered as the fixed IP address or if
the computer is located in the same subnet space:
IP address: 192.168.0.100
Recommendation for use:
The last set of digits must be a number between 1 and 253. In the example, "100"
has been selected.
Once the IP address has been entered, the subnet mask address must be entered. Click on the
Subnet mask field and the correct address is entered automatically.
Subnet mask: 255.255.255.0
Confirm your entries by clicking on OK.
6.3 Settings for use with Internet Explorer 8
Recommendation for use:
If Internet Explorer 8 is used, issues with the web interface may occur. If you
experience any problems, the IP address of the device must be entered in the local
intranet list in order to display the web interface correctly.
Open Internet Explorer and navigate to the Security tab under the following path:
ToolsInternet optionsSecurity
Switch to the Local Intranet icon and click on Sites.
Then click on Advanced.
In the Add this website to the zone address line, enter the device IP address and confirm with Add.
Default IP address: http://192.168.0.254
The IP address now appears in the list under Websites.