AirLive POE-100CAMv2 - Manual (Page 9)

AirLive POE‐100CAMv2 User’s Manual
8
Step 1
Using the screw holes on the mounting base
as a guide, make a mark with a pen for
drilling.
Step 2
Using a 3/16” drill bit, drill holes on the wall or
ceiling
Using the hammer, tap the white anchor into the
wall or ceiling until it was almost flush.
Note: The white anchor is used to hold the
screw when mounting onto a concrete surface.
If you are mounting onto a wooden surface, you
do not need the anchor. Use a 1/8 drill bit
instead of a 3/16” drill bit when you are mounting
onto a wooden surface
Fasten the mounting base onto the wall or
ceiling
Step 4 Step 3