AirLive POE-280HD - Manual (Page 82)

7. Setting-Advanced
AirLive POE-280HD User’s Manual
77
Alarm Sending:
Select On to set to send command with connection to the alarm detection.
Alarm-Motion Detection:
Click it on for using Motion Detection function as a sensor. You can set motion
detection function at the motion detection function screen.
Note: You can set motion detection at motion detection screen. (Please go “Setting →
Advanced → Motion Detection → Setting”)
z
Parameter: the parameter of CGI (defined in URL of HTTP → General) is from
your target device. For example, move=down.
z
Message: message will show up in the form of Message = PTZ down. If your
target device didn’t support the parameter of message, you can’t see the
message. So you can just take the message as a note. For example: PTZ down.
z
Parameter: the parameter of CGI (defined in URL of HTTP → General) is from
your target device. For example, move=down.
z
Message: message will show up in the form of Message = PTZ down. If your
target device didn’t support the parameter of message, you can’t see the
message. So you can just take the message as a note. For example: PTZ down.
Alarm-Network Link Down:
Click it on to receive a snapshot or a video clip while network link down. If Attached File
Type (go “Setting → Advanced → FTP client → General”) was clicked as video clip,
you can using Alarm buffer function as a sensor.