AirLive POE-FSH1008AT - Manual (Page 45)

4. Web Management
AirLive POE-FSH1008AT User’s Manual
40
 =Enable High Priority. After Enabled High Priority, the following enabled Port Based
parameter will become High Priority.
 Port Base: The selected port equipped with High Priority. The non-selected port is
Low priority. A packet received by a high priority port is handled as a high priority
packet.
 VLAN Tag: The switch follows the VLAN tag of the incoming packets to forward traffic.
VLAN Tag priority: high priority -> 4~7 ; low priority -> 0~3
 IP/DS: The switch follows the IP TOS / Diff Serve of the incoming packets to forward
traffic. The number set of the high priority is 10,18,26,34,46,48,56; the others are
mapped to low priority.
4.9.3 TCP/UDP Port Based
This page allows user to define the Option type of the pre-defined protocols or user-defined
protocols. Select the Option of the Protocol as below figure shown.