AirLive WHP-1130 - Manual (Page 21)

Pre-configuration can be carried out through WLAN Management System. As long
as the outdoor bridge and the management station are on the same physical Ethernet
LAN, WLAN Management System’s Kick Start function will find the outdoor
bridge and let you set basic parameters. Make connections as follows:
step 1. Using the supplied Category 5 waterproof cable, connect the waterproof
connector port of the outdoor bridge to the ODU port of DC injector.
step 2. Using Category 3 or higher UTP or STP cable, connect the RJ-45 port of
DC injector to a 10- or 10/100-Mbps Ethernet hub or switch, and connect
the management station to a hub or switch on the same LAN.
step 3. Connect the output cord of the power adapter to the DC injector’s DC
input jack, and plug power adapter into an AC outlet to power up the
outdoor bridge (see Figure 4 and Figure 5).
Outdoor Bridge/Outdoor Bridge Solution 11
Figure 5. Outdoor Bridge Installation