AirLive WHP-1130 - Manual (Page 34)

If a large wireless network using more than two outdoor bridges is to be constructed,
at least one of the outdoor bridges must be set to Point-to-Multipoint mode. Other
outdoor bridges can be set to either Point-to-Point or Point-to-Multipoint mode. In
this mode, up to six other bridges can be connected. Their MAC addresses must be
entered here.
For example; if Bridge A is the master bridge and needs to connect with Bridge 1 and
Bridge 2, then when setting Bridge A, the MAC addresses of Bridge 1 and Bridge 2
must be entered on the Bridge Mode page (Figure 17). Likewise, Bridge 1 and
Bridge 2 must be set to Point to Point mode, and Bridge A’s MAC address must be
entered as the peer bridge MAC address (Figure 16).
Config Window – Encryption Panel
Click the Encryption tab (Figure 18) to set up the security options.
Figure 18. Config window — Encryption panel
The default setting is WEP Disabled and initially the key sections are blank.
Outdoor Bridge/Outdoor Bridge Solution 24