Atop Technology AW5500 User manual User Manual
Page 26
Atop Industrial Wireless Access Point
AW5500
User Manual V. 1.3
21
The basic settings are explained in detail below:
Radio On: AW5500 supports up to three multiple SSIDs (AP1, AP2, and AP3).AP1 must
be enabled before you can proceed to AP2 and AP3. AP2 and AP3
’s settings are only
shown when they are enabled. When all three APs are disabled, wireless radio would
turn off completely.
SSID:
specifies the device’s wireless network name that other wireless devices should
use in order to associate with this AP. Each AP (AP1, AP2, and AP3) can have their own
SSID for better wireless network management. You can use the
“Scan network”
function to learn about the different SSIDs and channel numbers in the
device’s
surroundings, please be patient as this process might take as long as 10 seconds as
shown below. Once it has finished scanning, names and basic properties of neighboring
networks will be shown as in Figure 4.4. When no neighbors have been found the answer
is as follows Figure 4.5. Keep in mind that the SSID should be unique unless wireless
roaming is required.
Figure 4.3