Autoquip DOUBLE PANTOGRAPH LIFT - Manual (Page 45)

45
' PH ' CYLINDER REPACKING (Reference Figure 6)
21. Cycle the lift 10 to 15 times and repeat the bleeding operation by holding the
”DOWN” button for 30 to 40 seconds.
22.
Check the oil level in the reservoir with the lift in the fully lowered position.
Add oil as necessary (see “Routine Maintenance” for oil recommendations).
23. Clean or replace the oil filler breather cap if it appears dirty.
24. Clean up any debris and or spilled oil from the area.
PIPE THREAD SEALANT
Loctite PST #567 pipe thread sealant or equivalent is recommended. Do not use
Teflon tape. Tape fragments can cause malfunctioning of the hydraulic system.
Figure 6: Hydraulic Cylinder
GENERAL MAINTENANCE