MK Diamond MK-170 - Manual (Page 17)

17
water Pump Preparation
(A)
Install Water Pump Discharge
Fitting
(D)
Fill the Water Pan with clean
water (this should be done peri-
odically during cutting).
(G)
Connect the Water Pump pow-
er cord to the connection found
on the back of the motor.
(B)
Remove the Cutting Table from
the Water Pan
(E)
Place the Water Pump in the
Water Pan-ensure the pump
suction is covered.
(C)
Press the end of the Cooling
Transfer Tube onto the water
Pump Discharge Fitting
(F)
Install the Cutting Table; ensure
the pump power cord is sealed
in the slot behind the Post.
MK-170 Tile Saw SeTUP
1. To prevent the possibility of electrical shock, the MK-170 MUST be
de-energized when preparing the Water Pump for operation.
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
replacement parts.
waRNiNG