Caron CRSY102 - Manual (Page 23)

CRSY102 Operations Manual Rev G 1/31/2013 Page 23
Draining Reservoir
The re
circulator’s internal reservoir can be drained by either of two ways:
1. Turn off recirculator and unplug power cord
2. Remove right side (as viewed from front) access panel
3. Locate ball valve
4. Direct ball valve flow into an empty container and open valve. Because this
uses gravity to drain the reservoir, the ball valve must be located below the
reservoir.
5. After reservoir is drained, close ball valve and place inside recirculator
6. Install right side access panel.
OR
1. Turn recirculator off
2. Disconnect recirculator outlet line from the chamber
3. Direct recirculator outlet line into an empty container. This is not a gravity
drain and can be placed at any elevation.
4. Turn recirculator on
5. After water stops flowing, turn recirculator off.
If recirculator is not powered on for more than
three days or if it will be subjected to temperatures
below freezing, the water should be drained.