Comelit MT VIP SYSTEM - Manual (Page 34)

34
Manually programming buttons on external unit art. 4662C
1. Wire the external unit (see VIP/001).
2. Power up the external unit, carry out steps (1-4).
PR
PR
PR
PR
PR
PR
1 2
4
PR
PR
3
Set the Dip switch on the rear of the module
art. 4662C with the same code assigned
to the internal unit, in accordance with the
information provided in the programming
table on page 46.
The following procedure can be used to program buttons with ViP codes in the range between 1 and 255 only.
To program higher ViP addresses, use the ViP Manager software.