Comelit MT VIP SYSTEM - Manual (Page 48)

48
1. Access the installer menu.
2. Select the
Program monitor menu using buttons , .
3. Press to access it.
4. Press button to access the
ViP address menu.
5. Set the logic address for the main monitor in the same residential
unit using buttons , . Use buttons , to pass from one digit
to the next.
6. Move over the Slave option using buttons , and press to
confirm.
7. Move over the Slave address option using buttons , and
change the address using buttons , .
INSTALLER MENU
Configure monitor
CONFIGURE MONITOR
Reset configuration
Information
ViP address
Programming the ViP code for secondary Planux monitors
CONFIGURE VIP ADDRESS
ViP address
0
Master
Slave 0 0
Left Right
0 0 0 0 0 0 1
CONFIGURE VIP ADDRESS
ViP address
0
Master
Slave 0 0
Left Right
0 0 0 0 0 0 1
CONFIGURE VIP ADDRESS
ViP address
0
Master
Slave 0 1
Left Right
0 0 0 0 0 0 1
Configuring 1 - 2 or Self-ignition buttons
1. Access the installer menu.
2. Select the Program buttons menu by pressing , and
press to access it.
INSTALLER MENU
Configure buttons
3. Select the Configure self ignition menu by pressing , and
press to access it.
BUTTONS PROGRAMMING MENU
Configure Self-Ignition
1 2
CONFIGURE SELF IGNITION
Intercom
Self Ignition
Relay activation
Modify
4. Select the function you wish to assign to the button using ,
and press to confirm.
5. Once the desired function has been selected, press to change
the settings.
If the Intercom function is selected:
CONFIGURE VIP ADDRESS
0 0 0 0 0 1 0 1
ViP address:
Left Right
Slave
Master
Bracket:
1
` Select the fields which can be changed using , and change
the value using , or .
• The ViP address function determines the address of the internal
unit to be called once the button is pressed.
• The
Bracket function determines whether to call the main or
secondary internal unit with the same ViP address.
1 - 2 and Self-ignition buttons are programmed in the same way and
can perform the same functions. The programming procedure, which
applies to all 3 buttons, is described below.