Condux Winch Line Blower System - Manual (Page 15)

CONDUX WINCH LINE BLOWER 13
!WARNING: Winch line cable must be kept tight and must not be allowed to jump,
flap, surge, or become slack. Damage to utility service access vault equipment
may result.
7. If the winch line is proceeding smoothly and consistently, listen for the exit end
personnel to relay that missile and winch line have arrived. If the winch line does not
proceed smoothly or stops before reaching the exit, follow the troubleshooting
guide in the following section.
!DANGER: READ AND UNDERSTAND THE TROUBLESHOOTING INSTRUCTIONS
BEFORE USING THE WINCH LINE BLOWER SYSTEM. FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
Winch Line Blower Seal-off Body Removal
Figure 13: MISSILE ARRIVES
1. Once the missile arrives in the exit utility service access vault, close the control valve
on the control valve assembly. See Figure 13
2. Close the outlet valve on the air compressor and shut off the compressor.
3. Remove the air hose from the control valve assembly to assure all air pressure is
removed from the system and cannot be accidentally applied while in the access vault.
!CAUTION: ALLOW THE EXCESS AIR TO BLEED OFF FROM THE CONTROL VALVE
ASSEMBLY AND THE SEAL-OFF BODY ASSEMBLY PRIOR TO ENTERING THE
UTILITY SERVICE ACCESS VAULT.
4. Disconnect the air hose from the seal-off body assembly and pull the air hose out of
the utility service access vault and out of the way.