Safe operating practices – Condux Gulfstream 200 Micro Fiber Blower User Manual

Page 6

Advertising
background image

6

3.

Safe Operating Practices

Read and understand all procedures and safety instructions before using the
Gulfstream 200. Observe all safety information on this page and note specific safety
requirements as explained by procedures called out in this manual. Failure to follow
these instructions could result in serious personal injury, property damage or death.

A. woRk AREA SAfETY

1. Wear personal protective equipment: hard hat, safety glasses, safety shoes,

and leather work gloves.

2. The safe operation of this equipment requires that the operators be on

stable footing.

3. Stay clear of cables or lines under tension.
4. Stay clear of pressurized line and conduit.
5. Use the blower only for its intended purpose.
6. Do not place cable reel too close to unit. Place the reel far enough away from

the unit to ensure proper control.

7. Place cable grip on end of conduit to catch cable carrier and cable.
8. Keep hands away from tractor drive while blower is in operation.


b. PNEumATIC DEVICES
The Gulfstream 200 is a pneumatic device, using pressurized air to project cable at
high velocities. Please observe the following precautions when operating the blower:


1. Forced air creates flying debris. Always wear personal protective equipment.

Severe personal injury could result.

2. Ensure no personnel are in the destination access vault during the blowing

operation. Severe personal injury could result.


C. ELECTRICAL DEVICES
The motor, controller, and digital display are electrical devices. Electrical shock
hazards exist that could result in severe personal injury or death. Observe the
following precautions to avoid electrical hazards:

1. Do not operate in or near water. This includes setting the unit on a wet surface

or exposing to rain.

2. Do not remove the digital display cover. There are no user-serviceable parts

inside. Refer servicing to qualified service personnel.

3. The drive switch should be in the neutral "center" position before connecting

or disconnecting any cords.

Advertising