Black Box LR1102A-T1/E1 - Manual (Page 78)

Black Box LR11xx Series Router Configurations Guide
80
11.2Multipath Commands
The following table lists the multipath commands:
When multipath is disabled, Black Box selects the nexthop address with lowest ip address. For equal cost routes the
nexthops are stored in the increasing (ascending) order of IP address. show ip rpf command displays the selected
path, based on the configured multipath method and the nexthops of the best route to the IP address passed.
11.2.1 Multipath Examples
The following examples illustrate how the multicast commands are used:
The following command enables compatibility between the Black Box router and equipment running Cisco IOS.
Blackbox/configure/ip/multicast> multipath mode cisco
Blackbox/configure/ip/multicast>
The following command enables HRW compatibility.
Blackbox/configure/ip/multicast> multipath
Blackbox/configure/ip/multicast>
The following example shows how to see the reverse path forwarding information for the RP at 201.1.1.99:
Blackbox> show ip rpf 201.1.1.99
Task Command
Enabling HRW method Blackbox/configure/ip/multicast> multipath
Enabling Cisco method Blackbox/configure/ip/multicast> multipath cisco
Disabling Multipath Blackbox/configure/ip/multicast> no multipath
Blackbox/configure/ip/multicast> no multipath cisco
Display RPF selection Blackbox>show ip rpf <addr>
<addr> - source or RP address