ElmoMC ExtrIQ Gold Line Servo Drives-Gold Panther - Manual (Page 9)

Gold Panther Installation Guide
MAN-G-PANIG-EC (Ver. 1.000)
|Unpacking the Drive Components| www.elmomc.com
9
Table of Contents
Chapter 4: Installation
The Gold Panther must be installed in a suitable environment and properly connected to its voltage
supplies and the motor.
4.1. Unpacking the Drive Components
Before you begin working with the Gold Panther, verify that you have all of its components, as
follows:
• The Gold Panther servo drive
• The Elmo Application Studio (EAS) software and software manual
The Gold Panther is shipped in a cardboard box with Styrofoam protection.
To unpack the Gold Panther:
1.
Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Gold Panther you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Gold Panther. It looks like
this:
4. Verify that the Gold Panther type is the one that you ordered, and ensure that the voltage
meets your specific requirements.
The part number at the top provides the type designation. Refer to the appropriate part
number in the section Catalog Number at the beginning of the installation guide.