ETC Selador Series CE - Manual (Page 16)

11 Selador Series User Manual
Installing Secondary Lenses
Up to two secondary lenses can be installed in the slots towards the front of the fixture. The
stacking order and distance from the LED array are not important to the function of the
lenses. To avoid lenses being too loose and potentially overlapping each other, use the
narrower slots for thinner lenses.
To install secondary lenses:
Step 1: Loosen the screw on the end of the access panel that has the slot in it.
Step 2: Raise the panel out of the way, but leave it attached to the fixture.
Step 3: Slide the secondary lenses into the slots above the LEDs.
Step 4: Lower the panel and tighten the screw.
Loosen screw
Raise panel
Lens slot