Connections and addressing, Fuse – ETC Selador Series CE User Manual
Page 17
12
Connections and Addressing
Connect AC input power and DMX data cables to the appropriate ports as shown below.
Connect the incoming DMX data cable to the DMX Input connector. If you are
daisy-chaining the data to other fixtures or DMX-controlled devices, connect the next DMX
cable to the DMX Thru connector. The Selador Series fixtures require that the last fixture
on a DMX line be terminated with a 120
resistor between pins 2 and 3.
Connect the AC Input cable:
Align and insert the power connector. Twist the connector clockwise until it locks into place.
Disconnect the AC Input cable:
Slide back the locking tab, twist the connector counterclockwise and pull to unlock and
disconnect the power connector.
Fuse
The quarter-turn fuse-holder requires a straight blade screwdriver to remove and reinstall
a fuse. Refer to
for information about fuse types.
DMX Thru
Power
DMX Input
Addressing
Fuse
Data connections
Addressing and fans repeat per cell
Power connection
and fuses