EUCHNER RPS - Manual (Page 9)

Operating Instructions for Rope Pull
Switches RPS...
9
4 A
Connect pull rope fast-action clamping head (see Item 1).
Pre-tension pull rope.
B
Connect pull rope with turnbuckle as shown (3x rope clamp with thimble)
Display:
5
Basic setting should take place at a temperature corresponding to the prevailing operating conditions.
The length of the pull rope changes if there is a large change in the ambient temperature. Under these conditions,
long rope lengths mean a frequent change in the basic setting.
This can be remedied by re-adjustment (Item 5) or shortening the rope length (Table 3).
A Adjust the setting ring until the arrow tips of the
display are aligned with the marking.
Hold the fast-action clamping head tight when
doing this to prevent the pull rope from twisting
B
Adjust the turnbuckle until the arrow tips of the display are flush with the marking.
Display:
Mechanical function test
6 A
RPS...PR/PC
Pull up the blue RESET knob:
- safety contacts closed.
Actuate the pull rope:
- safety contacts open.
max. 200 N
S ma
x. 4
00
mm
B
RPS...SC...
Turn yellow actuating cylinder at the
RESET contact areas (blue) by 90° up
to the marking, then release.
Cylinder returns to initial position.
Operate the EMERGENCY STOP
button or the pull rope for each test
procedure.
max. 200 N
S
ma
x.
4
00
mm
Operate the pull rope forcefully several times in order to settle the pull rope section.
If necessary, carry out re-adjustment by means of the adjusting screw/turnbuckle.