Garland HO IN 3200 INDUCTION TEMPERATURE CONTROLLED BUILT-IN HOLD-LINE - Manual (Page 17)

Installation RTCSmp Built-In Temperature Controlled Hold-Line
Part # 4532287 Rev 4 (6/10/14) 17
4.6 Electrical Installation
IMPORTANT
 Refer to the electrical specifications in chapter 3 Dimensions and Technical Specifications AND the
markings/instruction labels on the unit. If the information differs between the data listed in the
manual and the markings on the unit, always follow the markings on the unit.
 Check and ensure that the supply voltage and the line current match the specifications given on the
rating plate. A stable mains supply must be provided.
CAUTION
Wrong voltage will damage the induction unit. Follow strictly
the specifications on the rating plate.
 The electrical connections must satisfy the national and local electrical codes.
 If ground fault current protective switches are used, they must be provided with selective activation and
designed for a minimum fault current of 30mA. Multiple generators with a mains connection must not be
connected to a single fault current protective switch.
 Always route sensor and communication cables separately and away from the coil cables.
 To manage electromagnetic interference, excess cable length can be dressed and tied in a serpentine or
S pattern, NOT coiled.
To setup the unit for operation:
1. Ensure the control knob is at the OFF-Position.
ON-Position
Any position where
“0”/Line is not pointing
straight up. OFF-Position
“0” / Line is pointing
straight up.
2. Remove all objects from the glass cook-top and check that the glass cook-top is neither cracked nor
broken.
CAUTION
Do not continue if the glass cook-top is cracked or broken.
Contact an authorized service agency for assistance.