GeoDesy FSO GD series User Manual
Page 31
com
http://www.geodesy-fso.com
31
GeoDesy Kft.
Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8.
Fax.:
06-1-481-2049
E-mail:
info@geodesy-fso.
For the sample we have used a very simple example. The surface is concrete and
the fixing material was Hilti HVU and the screw was Hilti HAS system. The steps are
as follows:
- Push the holder frame against the wall on the desired place
- Mark the place on the wall with permanent marker of pencil
- Drill the holes
- Clean the holes
- Place the small bag into the cleaned hole
- With a drill drive the screw into the hole
through the plastic bag
- Refer to the packaging about the
timing while the glue sets solid
enough to enable you to strain
the screw
- After it sets dry place the
mounting on to the screws
- After it sets dry for fastening fasten the bolts(the fastening power should be
min of 120Nm with a M16 sized bolt)
Note: Spacers and spring spacers should be used every time you fix a bracket as
the figure shows above.