Then you can fix the whole construction to a wall – GeoDesy FSO GD series User Manual
Page 50
com
http://www.geodesy-fso.com
50
GeoDesy Kft.
Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8.
Fax.:
06-1-481-2049
E-mail:
info@geodesy-fso.
Then you can fix the whole construction to a wall:
• Drill four holes, using the metal plate for measuring the places of the bores,
with a Ø8mm bit. The depth of the bores have to be a minimum of 50mm
• Put the four wall-plugs into the four holes
• Put the four M4,5x70 cross headed self-tapping-screws through the four free
holes of the metal plate
• Pull up the four 6x15 spacers
(the shorter ones) to the screws
• Tight the screws into the wall-
plugs, and tight it up as strong
as possible for the appropriate
fastening
Connecting the head to the
ODIU, and the ODIU to the
power supply
To make the connection for the 230VAC
5. remove the connector from the slot
6. connect the cables /using the cable shoe/
7. reconnect the connector to the slot
8. secure the connector in the slot /make sure it is seated
securely, connectors clips are latched/
For the power connection recommended to use two-wired Ø0,75mm cables.
For the power connection recommended to use three-wired
Ø0,75mm cables. The order of the connection can be seen
on the figure.
• P – Phase
• N – Neutral
S
S
t
t
r
r
u
u
c
c
t
t
u
u
r
r
e
e
o
o
f
f
t
t
h
h
e
e
g
g
r
r
o
o
m
m
m
m
e
e
t
t
s
s