Heidolph Hei-VAP Advantage - Manual (Page 33)

Set-up and Start-up
Hei-VAP Value, Hei-VAP Advantage
25
EN

Push the threaded connection (2) over the condenser flange.

Push the spring (3) over the condenser flange.

Screw the G6 (6) gland on the drive head (Figure 4 –10 (4)).

Insert the G6 intermediate part (5) with seal G6 (4) into the gland G6 (6).

Screw the center piece (1) with the screw (2) on gland G6 (6).

Insert the condenser in the upper cut on the center piece (1).
4.5.4 Mount the vertical condenser (G3-G6) in the condenser bracket
This step is omitted for horizontal condensers (G1).
 The support rod is installed.
Figure 4 –12: Condenser bracket (Glassware set G3 and G6)
1 Support rod 3 Boss head clamp
2 Condenser clamp
Version glassware set G3 and G6:
1. Push the boss head clamp (3) onto the support rod (1) and position with the clamp-
ing screw.
2. Place the condenser clamp (2) around the condenser and attach on the support rod
by using the clamping screw.

Position the support rod with Allen screws (also refer to chapter 4.5.1).
Version glassware set G5 (depending on coolant):

Completely place the cold trap bracket into the lateral hole of the boss head
clamp (2).

Lock with the clamping screw.

Place the cold trap bracket on the cold trap jacket.

Position the cold trap jacket with the tension band on the cold trap bracket.

Position the support rod (1) with an Allen screw (also refer to chapter 4.5.1).
Condenser mount-
ing
1
2
3