HiRO H50113 V92 56K - Manual (Page 23)

Hiro H50113
22
Commands
Most people use the communication software programs to tell
modems what to do. Therefore, you may not use the commands
in this chapter. However, if you prefer to communicate with your
modem directly, you can type the commands described below.
Here describes how to work in the terminal mode.
Typing Commands

Use the BACKSPACE key to delete typing errors.

Every command (except A/ and +++) must begin with the AT
or at prefix and be entered by pressing the <Enter> key.

When you see an n, replace the n with one of the letter or
numeric options listed for that command. For example, for
the En command, you might type ATE1.
Basic AT Command Guide
+++Escape Sequence
An escape sequence allows the modem to exit data mode and
enter on-line command mode. While in on-line command mode,
AT commands are sent directly to the modem. Use the return to
on-line data mode command to return to data mode.