HiRO H50113 V92 56K - Manual (Page 24)

Hiro H50113
23
Place a pause before and after the escape sequence to prevent
the modem from interpreting the escape sequence as data. The
length of the pause is set by register S12, the escape guard time.
Register S2 identifies the escape
sequence character.
A/—Repeat Last Command
Use this command to repeat the last AT command. The modem
repeats the command currently in the command
buffer. Do not use the AT prefix with this command. Do not
conclude the command with a terminating character
such as enter.
A—Answer
This command instructs the soft modem to go off-hook and
answer an incoming call.
E<value>—Command Echo
Use this command to instruct the modem to echo characters sent
to it. When the echo feature is selected,
characters sent to the modem are sent back to the host and
displayed on the monitor.
Result codes:
_
OK if <value> = 0—1.
_
ERROR if <value>
≠0—1.