HiRO H50113 V92 56K - Manual (Page 31)

Hiro H50113
30
Q<value>—Result Code Control
Result codes are informational messages sent from the modem
and displayed on the monitor. Basic result codes
include OK, CONNECT, RING, NO CARRIER, and ERROR. Use
the
Q<value> command to enable or disable
result code generation by the modem. If result codes are disabled
and an invalid parameter value is entered, the
modem does not generate an ERROR result code because result
codes are turn off.
Result codes:
_ OK if <value> = 0—1.
_ ERROR if <value>
≠0—1.
T—Select Tone Dialing
Use this command to configure the modem for DTMF tone dialing.
All subsequent D<dial string> commands use
tone dialing until either the P command or a pulse dial modifier is
received by the modem. Tone dialing is the default setting. This
command does not use parameters and generates an ERROR
result code when parameters are attached to the command.